12/08 Rev. 5.01-01 USER MANUAL Commissioning & Operation
AP7.t
4
Mounting the AP7.t
The AP7.t has been designed as a desktop printer, which means that it is
normally mounted in an upright position on a table [2]. Other sufficiently large,
level and sturdy surfaces can also be used as a base.
[2] The correct orientation of the AP 7.t
Checking the contents
Before using the AP7.t for the first time, take a few minutes to check
everything is in order:
« Ensure that the printer has not been damaged in transit. If the packaging has
been dented or torn, check the contents particularly carefully for shipping
damage.
« Are the articles listed below included in the box [3]?
WARNING!
When choosing a base for the printer, observe the following guidelines to
avoid dangerous operating conditions:
« The base needs to be at least as deep and wide as the printer itself.
« The surface needs to be level, solid and dry.
« The printer’s fan and ventilation slits must not be obstructed, as the device
may overheat otherwise.
« The printer must not be mounted in the immediate vicinity of other heat
sources.
« The environmental conditions specified (temperature, air humidity, etc.)
need to be complied with.
« The power cable should be run to the printer so that
– nobody will trip on it, and that
– the power plug can easily be pulled out if necessary.
To Next Page
Loading...
