Chapter 3: Remote Operation 15
Chapter 3: Remote Operation
Installation of PRE remote control in Pro Tools
includes:
• Making audio and MIDI connections to PRE
(See “Connecting Pro Tools | PRE to a
Pro Tools System” on page 16.)
• Configuring MIDI (See “Configuring MIDI Stu-
dio in AMS for Pro Tools | PRE” on page 18 or
“Configuring Pro Tools Software for
Pro Tools | PRE” on page 19.)
• Configuring Pro Tools (See “Configuring
Pro Tools Software for Pro Tools | PRE” on
page 19.)
This includes:
• Declaring PRE in the Peripherals dialog
• Mapping PRE outputs to an audio interface’s
inputs in the I/O Setup dialog
Once PRE is configured in Pro Tools, Mic Preamp
controls can be displayed in Pro Tools Mix and
Edit windows, and you can do one of the follow-
ing:
• Control PRE remotely from the Pro Tools Mix
or Edit window
• Use PRE front panel controls to adjust Mic Pre-
amp controls
• Use a control surface to adjust Mic Preamp con-
trols. For specific controls, see “Mic Preamp Re-
mote Control with Control Surfaces” on
page 27.
PRE Remote Control in Pro Tools
The following PRE front panel controls can be re-
motely controlled in Pro Tools:
• Input Gain
• Input Source
• Selecting one or more channels for editing
• Input Impedance (Input Z)
• 48V
• Insert
•Pad
• Phase Invert
• High-Pass Filter
The following PRE front panel controls cannot be
remotely controlled:
• Oscillator on/off
• MIDI channel assignment
• Changing the Peak Hold setting of front panel
Clip LEDs
• Clearing of Clips on the front panel
• Muting individual PRE outputs
To Next Page
Loading...