Pro Tools | MTRX Installation Guide32
To install an expansion card:
1 Standing at the back of the unit, use a #1 Phillips screwdriver to remove the faceplate covering the slot
where you want to install the card. For example, to install a card into slot 1 remove the two fasteners se-
curing the faceplate on slot 1 shown below.
Set the fasteners aside (you will use them to secure the new card to the unit after the card is installed).
2 Remove the expansion card from its packaging, being careful to handle it by its edges only.
3 Orient the card with its external connectors facing you (towards the back of the unit) and its PCIe
connector also facing the back of the unit.
4 Align the card in the corresponding guide rails on the bottom of the unit. Ensure any internal cables
(such as the ribbon cable near slot 8) are laid under the card.
Faceplate removed from slot 1
Guide rails for slot 1
To Next Page
Loading...
