Avid Technology S6L Control Surface Installing

S6L Control Surface RAM Expansion 11
4 24C Only: On some S6L-24C control surfaces the LVDS cable needs to be freed from the tray and disconnected before the tray
can be removed. If your 24C has a short LVDS cable, do the following.
• Using a 9/32 nut driver, remove the nut securing the LVDS cable to the tray then remove the cable clamp from its bolt.
• Carefully unplug the LVDS cable from the SBC. Use your finger of fingernail (or a small tool if the connection is too tight)
to disconnect the plug on the end of the cable from the connector on the board; do not pull on the wires.
5 Locate the captive screws securing the SBC Tray to the chassis (these are in addition to the captive screw under the shroud that
you loosened earlier).
• S6L-24C has four captive screws to loosen, shown below:
• S6L-16C has two captive screws to loosen (at the far left and far right in the image, above).
Figure 20. Bolt for LVDS cable
Figure 21. LVDS cable connection to SBC
Figure 22. Fasteners securing the SBC Tray to the chassis on S6L-48D, 32D, 24D, and 24C

Avid Technology S6L Control Surface Specifications

General

Brand	Avid Technology
Model	S6L Control Surface
Category	Music Mixer
Language	English