Chapter 2: Installing XMON 17
Locking the Surface to XMON
The Control Room and Monitor section of the MC Pro control surface must be locked to the XMON software application to retain
control of the studio levels while other applications or another workstation is in focus.
To lock the Control Room section to the XMON EUCON Software Application:
1 Make sure the MC Pro is attached to the workstation running the XMON EUCON Software Application.
2 Make sure the XMON EUCON Software Application is in focus (i.e., the front-most application).
The MC Pro Touchscreen displays that application’s name in the top-left corner.
3 Press the SETUP button in the Control Room section of the MC Pro control surface.
4 On the Touchscreen, select the Locking tab.
5 Press the Lock Section button on the screen.
A lock icon appears to the left of the button, which is now labeled Unlock Section. The software to which it is locked is listed
to the right of the button.
6 To unlock the section, press the Unlock Section button.
The locking action can be achieved using a keyboard and control surface shortcut:
1 Make sure the XMON EUCON Software Application is in focus.
2 Press and hold the computer keyboard Shift key, and then press the SETUP key in the MC Pro Control Room section.
The SETUP keys in both the Control Room and Monitor sections light dimly to indicate they are locked to an application.
MC Pro Locking tab
To Next Page
Loading...
Need help?
General
