Chapter 3: Using XMON 19
Chapter 3: Using XMON
XMON to EUCON Mapping
This section clarifies the terminology used for the XMON and MC Pro/System 5-MC hardware.
Control Room
The Control Room section of the MC Pro/System 5-MC can route input sources to three sets of outputs.
Main Spkrs Routes selected source(s) to the Main 1–8 (7.1-channel) outputs on the XMON hardware.
Alt 1 Spkrs Routes selected source(s) to the Alt 1–8 (7.1-channel) outputs on the XMON hardware.
Alt 2 Spkrs Feeds selected source(s) to the Mini 1–2 (stereo) outputs on the XMON hardware located on the TB/LB/UTIL connector
(XLR-M 6–7).
Monitors A–D
Monitor A Controls the output level of Headphones 1–2 located on the Control Cable Breakout Adapter.
Monitor B Controls the output level of STLS Output 1–2 located on the CUE OUTPUTS connector (XLR-M 1–2) on the back of the
XMON hardware.
Monitor C Controls the output level of Cue Output 1–2 located on the CUE OUTPUTS connector (XLR-M 3–4) on the back of the
XMON hardware.
Monitor D Controls the output level of Cue Output 3–4 located on the CUE OUTPUTS connector (XLR-M 5–6) on the back of the
XMON hardware.
To Next Page
Loading...
Need help?
General
