Cable Connections
Connecting External Power
NOTE: Do not perform this procedure if Power over Ethernet (POE) is used.
If PoE is not available, the dome camera can be powered with 24 V AC or 24 V DC through the removable
power connector:
1. Remove as much insulation as required to splice the supplied power connector to the power adapter
wires (not included).
Do not nick or damage the wires.
2. Remove the dummy plug from the power receptacle on the camera. See Top View on page2 for the
location of the external power receptacle.
3. Attach the power connector to the receptacle on the camera.
The power connector pin details are:
1. Brown — Power, accepts either polarity
2. Not used
3. Blue — Power, accepts either polarity
WARNING — This product is intended to be supplied by a UL Listed Power Unit marked “Class 2” or
“LPS” or “Limited Power Source” with output rated 24V AC +/- 10%, 37VA min. or 24V DC +/- 10%, 26W
min.
Connecting to External Devices
External devices, including audio and video devices, are connected to the camera through the I/O cable. The
pinout for the I/O connector is shown here:
Cable Connections 17
To Next Page
Loading...
