4. Install the 1 1/2” NPT mount adapter below the locking nut.
5. ConnectthesafetylanyardfrominsidetheNPTmountadaptertotheanchoronthedomecamera.
Installing the Male NPT Mount Adapter
CAUTION — The dome camera must be mounted as instructed below or problems with moisture may
arise and will not be covered by the dome camera warranty.
If you are installing the camera that is provided with a male NPT adapter (12W-H3-4MH-DP1-B or 9W-H3-3MH-
DP1-B), the dome camera must be mounted on a 1-1/2” NPT female threaded wall (CM-MT-WALL) or ceiling
mounting bracket. The mounting bracket is not included in the camera package.
If you are installing the camera that is provided with a female NPT adapter, see Installing the Female NPT Mount
Adapter on page7.
1. Determine where the cable will enter the pendant wall mount.
l If the cable will be pulled from inside the mounting surface, use the cable entry hole at the rear of
the pendant wall mount.
l If the cable will be coming out of an external conduit pipe, use the 3/4” NPT pipe entry hole on the
bottom of the pendant wall mount.
Installing the Male NPT Mount Adapter 9
To Next Page
Loading...
