4
English
Installation
Camera Package Contents
Ensure the package contains the following:
• Avigilon High Definition PTZ Dome Camera
• 1 ½” NPT Adapter
• T20 TORX tamper resistant key
• Teflon Sealing Tape
• RJ-45 crimp-on plug and weather-resistant housing
• External Power wiring harness, Avigilon Part #110-0017B
• External I/O wiring harness, Avigilon Part #110-0018B
Installation Steps
Complete the following procedures to install the dome camera.
1. Installing the Mount Adapter on page 4
2. Connecting Cables on page 7
3. Securing the PTZ Dome Camera on page 8
4. Assigning an IP Address on page 8
5. Accessing the Live Video Stream on page 9
Installing the Mount Adapter
The dome camera must be mounted on a 1-1/2” NPT male threaded
wall or ceiling mounting bracket. The mounting bracket is not included
in the camera package.
1. Wrap the thread of the mounting bracket with the supplied
Teflon sealing tape to create a water tight seal around the
Caution — The dome camera must be mounted as
instructed below or problems with moisture may arise and
will not be covered by the dome camera warranty.
To Next Page
Loading...
Need help?
General
