8
English
Securing the PTZ Dome Camera
After the cable connections have been made, secure the PTZ dome
camera to the mount.
1. Push the PTZ dome camera into the 1 1/2” NPT mount
adapter then twist until it locks into place.
NOTE: Be careful not to trap any cables between the dome
camera housing and the mount adapter.
2. Use the tamper resistant key included with the dome
camera to tighten the three tamper proof screws in the
mount adapter.
Assigning an IP Address
The camera automatically obtains an IP address by default. Once
connected to a network, it attempts to locate and obtain an IP address
from a DHCP server. If this fails, Zero Configuration Networking
(Zeroconf) is used to choose an IP address. When the IP address is
set using Zeroconf, the IP address is in the 169.254.0.0/16 subnet.
To Next Page
Loading...
Need help?
General
