Configuring Windows Embedded 7
When you start the HD Video Appliance for the first time, you will need to configure the Windows operating
system that is installed on the appliance.
1. On the first screen, carefully scroll through the list and select your preferred language.
NOTE: You will not be able to change this setting after Windows applies your settings at the end of this
procedure.
Figure 1: The language selection screen during initial Windows set up.
2. Click Next.
3. Select your locale preferences then click Next.
4. Enter a user name for accessing the appliance. You can also enter a unique computer name or use the
default. When you are ready, click Next.
5. Set a password for the user name you entered on the previous screen. When you are ready, click Next.
6. On the following page is the end user license agreement for the Windows operating system. Review the
terms then select the I accept the license terms check box and click Next.
7. Select the correct date and time for the system then click Next.
8. Select the network mode for the appliance. The recommended option is Work Network.
Next, Windows applies all your settings and restarts. Once restarted, you will need to license your Avigilon
Control Center system.
Configuring Windows Embedded 7 2