Configuring the Network
Depending on how you intend to use the HD Video Appliance, you may choose to configure the network switch
component of the appliance differently.
The three most typical network configurations are:
1. No DHCP server — the HD Video Appliance and the connected cameras will run as a self contained
system without a DHCP server.
This configuration is most likely used by a small business that may not have a network infrastructure, and
prefers to use the HD Video Appliance like a traditional closed circuit surveillance system.
2. External DHCP server — the HD Video Appliance and the connected cameras will work with an existing
DHCP server on the network.
This configuration is most likely used by a small office that already has some network infrastructure that
will be used with the appliance, like a router that gives the office computers internet access.
3. Internal DHCP server — the HD Video Appliance will act as the local DHCP server for the connected
cameras and any other devices that may also be connected to the appliance.
NOTE: The HD Video Appliance is intended to be used for connecting and powering IP cameras, not for
general computer networking. However, if you prefer, the appliance can be configured to do so.
This configuration is most likely used by a small business that prefers to use the appliance switch
component instead of a router for connecting all network devices together. Other network devices can
include voice over ip (VoIP) phones or external network drives.
Complete the procedure that will configure your preferred network:
Configuring a No DHCP Network 5
Configuring an External DHCP Network 6
Configuring an Internal DHCP Network 7
Configuring a No DHCP Network
If you plan to connect cameras directly to the HD Video Appliance and run a self contained system, all you need
to do is connect cameras directly to the numbered ports.
5 Configuring the Network
To Next Page
Loading...
Need help?
General
