Broadcast a Message to call boxes from the Call Commander:
1. With the Call Commander handset hung-up press the All Call button.
2. Lift the Call Commander handset and press and hold the Select button. While pressing and
holding the Select button, speak the desired broadcast message (Maximum 10 seconds),
then release the Select button.
3. To review the recorded message, press and release the Select button.
4. To broadcast the message, hang up the handset and press the Select button.
5. The message will broadcast to four Call Boxes at a time until the message has been played
at all Call Box locations. When the broadcast is completed, the Call Commander display will
go back to its home screen for normal operation.
NOTE: During All Call, the Call Commander cannot answer an incoming call until message
broadcast is complete.
WTG- Call Waiting to be Answered
ACT- Active Call
HLD- Call on Hold
EXT- Call Box using External Line
3WY- Call Box in a Call with External Line and Call Commander
To adjust ringer volume: When the system is idle, press the Volume button on the Call Commander.
Each time the Volume button is pressed, the volume setting on the Call
Commander display will scroll through 0 to 3 (0 being lowest, 3 being the
highest). This setting will be saved automatically.
To adjust handset volume: When the Call Commander is on a call, press the Volume button on the
Call Commander. Each time the Volume button is pressed, the volume
setting on the Call Commander display will scroll through 0 to 3 (0 being
lowest, 3 being the highest). This setting will be saved automatically.
Adjust Volume on a Call Commander:
Page 16
Call Indicators at the Call Commander:
To Next Page
Loading...