144
7.4.3 The System Page
The [System]
page includes the following options:
N
AME DESCRIPTION
Factory
Default
Restore the network security settings to
factory default.
Reboot Restart the scanner. The Net LED light
turns off and then turns on.
To restore network security settings to factory default,
1. Press the [Factory Default] button. A [Confirmation]
dialog box appears.
2. Press [Yes] to complete the settings.
3. The blue [Wi-Fi LED] light
turns off.
4. Wait for about 30 seconds until the blue Network LED turns
on and starts blinking again.
Alternatively,
You may press the [Reset] button on Scanner to restore
network security settings to default.
1. Use your pen to press and hold the [Reset] button for
about 5 seconds until the blue network LED turns off.
2. Wait for about 30 seconds until the blue Wi-Fi LED turns on
and starts blinking again.
To Next Page
Loading...
