48 AutoView 3050/3100/3200 Switch Installer/User Guide
Figure 4.2: LDAP Overview Page in the OBWI
To configure LDAP server parameters:
1. Select Appl
iance - Appliance Settings - User Accounts - LDAP Accounts - Overview.
2. Identify the primary and secondary server address
, port and access type in the appropriate
fields or radio buttons.
3. Click Save.
LDAP Search parameters
On the LDAP Search page, you can configure the parameters used when searching for LDAP
directory service users.
Use the Search DN field to define an ad
ministrator-level user that the appliance uses to log into the
directory service. Once the appliance is authenticated, the directory service grants it access to the
directory to perform the user authentication queries specified on the Query page. The default values
are cn=Administrator, cn=Users, dc=yourDomainName and dc=com and may be modified. For
example, to define an administrator Distinguished Name (DN) for test.view.com, type
cn=Administrator, cn=Users, dc=test, dc=view, and dc=com. This Search DN field is a required
field unless the directory service has been configured to enable anonymous search, which is not the
default. Each Search DN value must be separated by a comma.
To Next Page
Loading...
Need help?
General
