Avocent DSR Series - Assigning Target Device Names; Figure 3.6: OSCAR Interface Setup Dialog Box; Figure 3.7: OSCAR Interface Names Dialog Box

26 DSR Switch Installer/User Guide
Figure 3.6: OSCAR Interface Setup Dialog Box
Assigning target device names
Use the Names dialog box to identify target devices by name rather than by port number. The
Names list is always sorted by port order. You can toggle between displaying the name or the EID
number of each DSRIQ module, so even if you move the target device to another port, the name
and configuration will be recognized by the switch.
NOTE: When it is initially connected, a target device will not appear in the Names list until it is powered up. Once
an initial connection has been made, it will appear in the Names list even when powered down.
To access the OSCAR interface Names dialog box:
1. If the OSCAR interface is not open, press Print Screen. The Main dialog box appears.
2. Click Setup - Names to open the Names dialog box shown in Figure 3.7.
Figure 3.7: OSCAR Interface Names Dialog Box