Execute the following steps to define your camera settings:
1. Use the Camera Settings tabs (outlined below) to change the OSD settings as if you are using the
remote control.
2. If you have changed a value with the remote control, update the WebGUI using the REFRESH button.
A picture is shown ONLY if the main video stream is set to H264.
Focus
Figure 21: WebGUI > VIDEO > Camera Settings > Focus
The Focus settings are explained below.
Focus Mode
Auto The camera automatically adjusts the focus position based on the contents of the captured object.
Manual The user is able to set a fixed focus position manually. This can be useful when the contents of the filmed object are not
clear towards the background and the autofocus has difficulties finding the correct focusing.
One-push The camera will focus once and will keep the focus in that position until another focus command is sent.
AF-Mode
This setting defines the area where the autofocus is aimed at and is not visible at manual focus.
Front Focus: Focus close to the camera has priority. In the absence of an object or person nearby, the camera will focus on an object
or person at a greater distance.
Back Focus: Focus far from the camera has priority. If there are no objects or persons to focus on from far, the camera will adjust the
focus to an object or person that is closer to it.
Meeting: For general meeting scenarios. Focussing straight forward. Camera considers also focussing on the whole room or stage.
Moving Objects: For focussing in the whole room or on stage. Re-focussing is done when the object or person is moving around.
Center Focus: Focus straight forward at the middle of the room or on stage. Re-focussing is done when the object or person moves.
AF-Sensitivity
Sets the level of speed with which the autofocus responds. This can be useful if you have people walking through
the picture. If the setting is ‘High’, the camera will respond immediately. The camera will remain less responsive
to sudden and brief changes when the AF-Sensitivity setting is set to 'Low' or 'Medium'. This setting is visible and
applicable only when the Focus Mode is set to 'Auto'.
In some cases the autofocus will have some difficulties to focus. We are highly recommended you to focus
manually in order to avoid autofocus issues. See also Troubleshooting/ Image in this manual.
35
To Next Page
Loading...
