Other Key Combinations
The following key combinations on the Remote Controller have specific functions. These are:
Combination Function
[*] → [#] → [4] Menu set to English
[*] → [#] → [6] Restore factory defaults
[*] → [#] → [9] Flip switch (just temporary flip to view the image flipped)
[*] → [#] → [Auto] Enter into the aging mode, only for quality control purposes
[*] → [#] → [Manual] Restore the default username, password, and IP address
[#] → [#] → [#] Clear all presets
[#] → [#] → [0] Switch the video format to1080p60*
[#] → [#] → [1] Switch the video format to 1080p50*
[#] → [#] → [2] Switch the video format to 1080i60*
[#] → [#] → [3] Switch the video format to 1080i50*
[#] → [#] → [4] Switch the video format to 720p60*
[#] → [#] → [5] Switch the video format to 720p50*
[#] → [#] → [6] Switch the video format to 1080p30*
[#] → [#] → [7] Switch the video format to 1080p25*
[#] → [#] → [8] Switch the video format to 4K60*
[#] → [#] → [9] Switch the video format to 4K50*
The camera returns to the video output setting of the system select after a reboot.
Use ONLY presets between 0-9 when using the Remote Control. For presets 10 or higher you need a serial or
IP connection!
Tally Light Functionality
The tally light is the LED light on the front of the camera and can ONLY be controlled through the VISCA
commands or even by NDI with the CM93-NDI camera. The tally light cannot be controlled through the WebGUI
or the OSD menu of the camera. See the VISCA commands in appendix A in this manual.
52
To Next Page
Loading...
