EasyManua.ls Logo

Avonic CM93-IP-B - Page 37

Avonic CM93-IP-B
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
dark parts of the image, as they will become lighter/more grey as the level of DRC increases. Like the Gain Limit the
DRC will add more noise to the picture.
Manual Exposure Mode
Figure 24: WebGUI > VIDEO > Camera Settings > Manual Exposure Mode
In Manual exposure mode, you can manually set the shutter, Iris and DRC options.
Shutter
The shutter setting determines the amount of time per second that the sensor is exposed. The range of the
shutter speed setting is 1/25th of a second (40 milliseconds) to 1/10000th of a second (0.1 milliseconds). If you
shoot a video with a shutter time of 1/25th of a second, you can imagine that the video becomes blurry and
overexposed. The faster the shutter is set to open and close, the sharper your filmed object will be. However, the
amount of light that falls onto the sensor is also diminished. A higher shutter setting comes in handy when you have
regularly a fast moving person or object before the camera. Otherwise keep the shutter as low as possible.
If you are inexperienced or if the light conditions change a lot, it’s best practice to keep the camera on the
automatic exposure setting.
Iris
The Iris is a part of a lens that regulates the amount of light that passes through the lens and onto the sensor, by
altering the diameter of the hole through which the light enters. The diameter of the hole is measured in F-stop
value. A higher value results in less light, while a lower setting results in more light. This setting affects the length of
the depth of field. The higher F-stop you use, the deeper your depth of field. Reason: the smaller the aperture, the
more focused the light beams will be, resulting in a more focused image. This implies that the light beams are highly
"concentrated," causing the camera to focus at a point further away (making the camera in the picture sharp).
However, the object located in front (i.e., the IR remote control) is not within the focus range, resulting in an out-of-
focus image.
A higher F-stop value comes in handy when the filmed person or object is in great distance from the camera (and
zooming in is not possible). At the other side the lower F-stop values are useful when the filmed person or object is
close to the camera.
Figure 25: Exposure > Manual with Iris F2.0 (left) and Iris F6.8 (right)
37

Table of Contents

Related product manuals