4
IMPORTANT SAFETY INSTRUCTIONS
Please read all instructions carefully before proceeding
further to prevent the risk of fire, electric shock, personal
injury or damage to the Blower Unit. This manual
provides a general insight on the installation and may
not include solutions for all possible issues that may
occur.
Important: Read and save these instructions.
Installer: Please leave these instructions with the
owner.
Owner: Please keep these instructions for future
reference.
In case of this manual destroyed or lost, please visit
https://www.awoco.com and download a digital version.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR
PERSONAL INJURY, PLEASE READ THE FOLLOWING
CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL,
OPERATE OR MAINTAIN THE BLOWER UNIT:
• Always disconnect, lock and tag the power source
before installing or servicing the Blower Unit. Failure
to do so may result in fire, shock or serious injury.
• Installation and eletrical wiring must be done
by qualified technician(s) in accordance with all
applicable codes and standards, including fire-rated
construction.
• When cutting or drilling into walls or ceilings, please
be careful not to damage any eletrical wirings and
other hidden utilities.
• Verify and ensure the rated voltage and frequency
of the Blower Unit is in compliance with the nearby
power source.
• Always unplug the Blower Unit from the power
source before cleaning it.
• Use the Blower Unit only as directed in this manual.
Do not use it to vent hazardous or explosive
materials or vapors.
• Clean the Blower Unit regularly to prevent it become
blocked or clogged. Good air flow is essential for the
Blower Unit to work propoerly.
• Do not install, repair or replace any parts of the
Blower Unit or Hood Unit unless you are instructed
to do so by the manufacturer.
• Do not tamper with or modify the PCB.
• This Blower Unit requires a duct to vent the air
outside. Do not vent the air into spaces within walls,
ceiliings, attics, crawl spaces or garages.
• The recommended installation height for the Hood
Unit is 24" minimum and 30" maximum above the
cooking surface to the bottom of the Hood Unit.
Note
• For SP-06 model: This model has a built-in
damper. Additional damper is
not needed.
• For SP-08 model: Damper is not included in this
model. Please purchase it
should you prefer to have one.
• Optional Control Unit:
Read and Save These Instructions
To Next Page
Loading...
