AXIS 211M - Using the Network Camera
8
Accessing the AXIS 211M from the Internet
Once configured, your AXIS 211M is accessible on your local network (LAN). To access the camera from the
Internet, network routers must be configured to allow incoming traffic, which is usually done on a specific port.
To do this, enable the NAT-traversal feature, which will attempt to automatically configure the router to allow
access to the camera. This is enabled from Setup > System Options > Network > TCP/IP Advanced.
For more information, see NAT traversal (port mapping), on page 32. See also the AXIS Internet Dynamic DNS
Service at www.axiscam.net or, for Technical notes on this and other topics, visit the Axis Support Web at
www.axis.com/techsup
To Next Page
Loading...
