Axxess AXSWC - Page 7

To Next Page

To Previous Page

AX SWC

Changing Radio Type

Integrate • AxxessInterfaces.com

If the AXSWC inteface detected the vehicle properly, yet the sequence of light ﬂashes do not match the radio installed, then the radio must be manually assigned to the

interface.

This feature can be performed by either following the steps below, through a Windows based computer using the Axxess Updater, or through the Axxess Updater app

available from the Android/Apple mobile devices app store.

Note: Apple mobile devices will require the use of the AXHUB-1 for this feature.

Attention! If more than 10 seconds elapses between steps, the procedure will abort, and the light in the inteface will go out. The interface may not function properly and

may need to be reset and reprogrammed.

1. Program the interface to the vehicle following the vehicle speciﬁc document.

2. Turn the radio off.

3. Cycle the key off, then back on.

4. Wait until the light ﬂashes Green one time then goes out.

Press and hold the Volume Down button on the steering wheel until the light turns solid Red, then release. The light will then go out indicating the interface is in

Changing Radio Type mode

6. Reference the Radio Legend for the radio number preferred.

Press and hold the Volume Up button on the steering wheel until the light turns solid Red, then release. Radio number 1 has now been programmed. Repeat this step

for the desired radio.

8. Once the desired radio has been selected, press and hold the Volume Down button on the steering wheel until the light turns solid Red. The light will remain solid

Red for 3 seconds while it stores the new radio information. After the light goes out, turn the radio on and test the steering control wheel controls.

Radio Legend

Radio # Radio

1 Eclipse (Type 1)

2 Kenwood

3 Clarion (Type 1)

4 Boss (Type 1) / Dual / Sony

5 JVC

6 Pioneer / Jensen

7 Alpine

8 Visteon / Boss (Type 4)

9 Valor

10 Clarion (Type 2)