Azbil PTG60 - Page 23

Azbil Corporation Installation
Model PTG60/70/71/72 - Smart Pressure Transmitter 2-3
Handling precautions
• )RUPRGHOV37*BB*DQG37*BB$6HFXUHO\ZUDSVHDOLQJWDSHDURXQGWKHMRLQW
RIWKHFRQQHFWLQJSLSHWRSUHYHQWSURFHVVOHDNDJH
)RUPRGHO37*B%VHDOWKHMRLQWZLWKDJDVNHW
• 8VLQJZUHQFKHVVHFXUHO\WLJKWHQWKHZHWWHGSDUWDQGFRQQHFWLQJSLSHRIWKH
Transmitter. In so doing, use the wrenches to hold the parallel chambers at the
wetted part. Do not tighten it by holding the housing of the product as this may
cause damage to the Transmitter. Avoid holding the housing when tightening
ZLWKRXWDZUHQFK6HH)LJXUH
• Avoid installing the Transmitter with its front side facing down. Doing so invites
water, dirt and other sediment to deposit at the wetted part, causing an inaccurate
measurement.
• ,IWKHSURFHVVWHPSHUDWXUHH[FHHGV&)WDNHVRPHPHDVXUHVVXFKDV
installing a siphon, to defuse the high temperature at the wetted part so it does not
H[FHHG&)
• Install the Transmitter in a location where the liquid process does not freeze.
2WKHUZLVHWDNHVRPHPHDVXUHVWRNHHSWKHSURFHVVÀXLGIURPIUHH]LQJ
• ,QVWDOOWKH7UDQVPLWWHULQDORFDWLRQZKHUHWKHUHLVQRH[FHVVLYHLPSDFWYLEUDWLRQ
RUSUHVVXUHVXFKDVZDWHUKDPPHULQJ
• 'XULQJ¿OOLQJWKHFRQQHFWLQJSLSHZLWKSURFHVVOLTXLG03D^36,`
or an equivalent pressure may be applied. Do not screw the Transmitter into a
FRQQHFWLQJSLSHGXULQJ¿OOLQJDVLWPD\OHDGWRFULWLFDOGDPDJHWRWKH7UDQVPLWWHU
6HH)LJXUH
Sealing tape
Figure 2-2 Installation precaution 1