EN-25 EN-26
Video Resolution
Allow to choose the desired video resolution and fps(frames
per second). Higher resolution and fps videos result in
smoother videos, but also take more storage space.
-2560x1440P 25fps+1280x720P 25fps (Default)
-2340 x1296P 25fps+1280x720P 25fps
-1920 x1080P 30fps+1280x720P 25fps
Loop Recording — 1min/ 3mins(Default)/ 5mins
Here select the length(1/3/5 min) of each video clip for the
loop recording. This function allows the dash cam to
continuously record.
Please notice: The dash cam will keep deleting the oldest files
automatically when memory card gets full so that it can keep
recording over and over.
Audio Recording — On(Default)/Off
The dashcam has built-in microphone to record audio with
video. You can choose to record mute video by choosing OFF.
G-Sensor — Off/ Low/ MID(Default)/ High
G-sensor is a 3-axis impact gravitational accelerometer,
designed to detect physical and gravitational forces on the
dash cam. Once G-sensor has been triggered due to physical
or gravitational impact force on the camera, the current
video file will be locked as an emergency file so it won't be
deleted by loop cycle function. The higher the G-Sensor
sensitivity is, the less force will be needed to trigger
automatic file protection.
1. Please download and update the latest firmware from the
manual.
2. Custom-designed JYX04 Micro 3-Lead Hardwire Kit is required to
use this new feature. Not included in the packaging,
on Amazon search: JYX04 Micro 3-Lead Hardwire Kit for M301
Dash Cam
Note:
Parking Mode
This function will ONLY work when 3-Lead Hardwire Kit is installed
properly, the output current of Hardwire Kit needs to reach 2.5A.
Then select parking mode. This parking mode has two options
to choose from.
9.1 Video Settings
Time-Lapse Parking Mode:
*
1. When you turn OFF the car's engine and turn the key to the lock
position. Then the camera will STOP the continuous video recording
and it will go into the timelapse 1fps recording mode automatically.
2. Now while this timelapse is being recorded, if someone hits your
car and if the impact reaches the set G-Sensor level, then the
camera will start to record 1-min continuous video, save & lock that
video in Event folder > then return to the timelapse 1fps recording.
3. Now when you start your car for the next time, the camera will
automatically STOP the timelapse parking mode. Then it will go
into normal video mode automatically to start the continuous video
recording.
To Next Page
Loading...
