User Manual
Page 38 of 44
4. Can I connect a second WL559E to the current WL559E that I have
already connected to my wireless AP/router?
It is possible to extend the wireless signal of your first WL559E by
connecting another WL559E to it. But you must understand that each
time the wireless signal is repeated, the repeated signal will be half of
the original. So in theory, if your wireless AP/router gives a total
throughput of about 50Mbps, after the 1st WL559E it will be around
25Mbps and 12.5Mbps after the 2nd WL559E. Actual throughput might
be lower than this after taking in consideration walls and other
interference in the wireless medium.
5. Can I use the WL559E with my old wireless-G AP/router?
Yes. Even if the WL559E is a wireless-N repeater, it is backward
compatible with wireless b and g devices including AP and clients.
6. Why can't I connect to the Internet when I pressed the WPS on the
WL559E?
The WPS button of the WL559E is meant for connecting your AP/Router
and wireless devices to the WL559E. When the WPS is activated, Light in
Amber color will blink within 2 minutes. If WL559E was already
connected to any AP/Router, Internet on the WL559E will stop to scan
for connecting AP/Router or wireless client. If in any case the
association is not successful you will need to reboot the WL559E to
restore its connection to the Internet.
To Next Page
Loading...
