User Manual
Page 37 of 44
FAQs
1. Why can’t I access the Web UI of my WL559E?
Ensure that the Ethernet cable is properly connecting your WL559E’s
and Desktop/computer through both of the device’s Ethernet ports.
You may turn-off / disable the wireless adapter of your computer (if
applicable and launch a Web browser. It should redirect you to User
Interface of the WL559E (If in any case it does not type
http://10.0.10.254 on your Web browser Ex: Internet Explorer, Firefox,
or Chrome etc.)
2. What if I want to change some of the configurations set on my WL559E
after it has been previously configured and connected to my wireless
AP/Router?
If you are connected to the WL559E’s wireless network, you may just
open your Web browser and type http://10.0.10.254 on the address
bar to get to the Web user interface.
Another way is to connect your desktop/pc to the WL559E using an
Ethernet cable, and type http://10.0.10.254 on the address bar to
get to the Web user interface.
3. Will the WL559E increase the range and throughput of my wireless
AP/Router?
The WL559E will extend the range of your wireless AP/router but it will
NOT increase the throughput. All repeaters will sacrifice half of the
bandwidth available from the primary router for all of the clients
wirelessly connected to the repeater. This is a result of the repeater
taking turns talking to not just one partner, but to two, and having to
relay the traffic between them.
To Next Page
Loading...
