OPTIONS Ramp/Taper Mode
Vista
™
basic Instructions for Use 13/25
950787 Rev 6/02
To Clear Ramp/Taper Mode
1. Press OPTS until display shows RAMP TAPER MODE.
2. Press CLR.
3. Press YES to clear all the data in Ramp/Taper Mode.
4. Press ON and continue to program a new Ramp/Taper program.
To Exit Ramp/Taper Mode
1. When infusion is complete, press to stop the KVO.
2. Press EXIT.
3. Press END to return to Continuous Mode.
Fast Taper
The infusion can be interrupted to begin an early taper down process during the
Ramp/Taper Mode Infusion.
1. Stop the infusion.
2. Press FAST.
3. Enter the FAST Taper Time in hours and minutes.
4. Press OK.
5. Press to start the infusion. Check for drops in the drip chamber.
To Next Page
Loading...
