B. Braun Vista basic - Additional Functions with Inserted Service Plug; Disabling the Occlusion Sensor

Service Program
Additional Functions with
inserted Service Plug
Software Version andUser Languages
1. Insert service plug into the MFC socket at the rear of the unit.
2. Switch on unit and keep the ON/OFF button pressed
(for max. 15 s).
3. The software version and user languages are displayed
inthe LCD.
4. The unit is switched on when the ON/OFF button is released.
5. ** appears in the LCD if the service plug is inserted,
Two LEDs are integrated in the service plug:
- green = Power supply active
- red =Alarm
The following conditions are active:
- The operating alarms are muted.
- All special functions are accessible (including the disabled).
- The special functions are slightly modified. (Example: SM
battery capacity has key for 0 min/32 min presetting).
- The battery capacity display switches between the nominal i )
and the actual capacity. If the maximum battery capacity is i
not reached ”?” will be displayed before the new nominal ca-
pacity.
- The tube type will be displayed in the tube selection menu.
Disabling the Occlusion Sensor
The electronic pressure monitoring can be deactivated to check
the mechanical occlusion pressure.
1. Select “Occlusion Pressure” with the SM key.
2. Then select “mechanical”.
3. Return to the main menu with END.
A too low pump speed is indicated in the display by "Pressure
Alarm” with underlined stars.
The display "Pressure Alarm” with underlined questions marks
indicates that no tube has been inserted.
Vista basic 950971 Rev A (5/04)