Troubleshooting 179
5
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
19
You tried to initialize the embroidery unit with the embroidery foot
lowered.
20
A pattern was being retrieved from a USB flash drive (USB flash
memory) containing more than 200 embroidery patterns (including
folders).
In addition, this message will appear if embroidery patterns containing
too many colors have been saved on the USB media, even if it contains
data for no more than 200 patterns (including folders).
21
The start/stop button was pressed after selecting a pattern which is
saved in the machine's memory or entered from the USB port without
pressing (Retrieve key).
22
The reverse/reinforcement stitch button, needle position button or
thread cutter button was pressed while the bobbin winder shaft is
moved to the right.
23 A pattern is being saved.
24
The start/stop button or reverse/reinforcement stitch button was pressed
when no pattern is selected.
25
Bobbin thread has run out.
Little bobbin thread remains.
26 When the embroidery unit is attached.
27 You tried to set a number of characters that will not fit within the frame.
No
Error Message Probable Cause
To Next Page
Loading...
