After reaching the end of the stitching, press
(Reverse/reinforcement stitch button)
once.
Buttonholes or bar tacking require
reinforcement stitching making this operation
unnecessary.
X After the reverse stitching or reinforcement
stitching has been done, the sewing machine
stops, and the thread is cut.
Memo
z Press (Start/stop button) when you
want to stop the sewing machine in the
middle of sewing without programmed
thread-cutting (for example, when you want
to change the sewing direction). The sewing
machine stops without programmed thread
cutting.
Press (Reverse/reinforcement stitch
button) at the end of the stitching.
a Stop the machine and change the sewing
direction.
b Start the machine again.
c The thread is cut here.
z If the power is turned off, programmed
thread-cutting will be turned off.
Mirroring stitches
You can sew the mirror image of a stitch horizontally
(left and right).
Press on the screen.
X It turns to , and the pattern displayed at
the top of the screen is mirrored.
Memo
z To cancel the mirror image setting,
press .
z Mirror image is not possible for buttonholes
and other stitches where shows.
z When the sewing machine is turned off, the
mirror image setting is cancelled.
The thread is cut here.
1
2
4
3
a
b
c
To Next Page
Loading...
