BabySense 7 - Warnings; Principal Of Operation; Installation

1
Ensure you read this user guide before installing and
using the product.
Babysense is a high quality, high sensivity electronic
device, which must be handled with care:
• Do not handle roughly, drop or throw.
• Follow the installaon instrucon carefully to ensure
the device is installed securely and correctly.
• Babysense is not a toy. Do not allow children of any
age to play with it.
• Do not put any addional baby or pet in the bed.
Babysense cannot be used for two infants in one bed.
• Do not operate the unit in the presence of
electromagnec interference.
• Portable and mobile RF communicaons equipment
may effect operaon of this device.
• You must undertake the performance test daily and
every me you move the monitor, change bedding or
relocate crib/bed posion (as set out on page 3).
• Do not operate vaporizer or venlator directly towards
the bed.
• To avoid possible danger from sensor cords, ensure
that excess cords are pulled back under the maress,
secured with the included cable e and are not visible
or reachable.
• Install 4 new and idencal size AA 1.5 volt baeries,
preferably alkaline.
• IMPORTANT: It is strongly advised that parents and
caregivers learn how to give first aid.
• Please remove baeries if the device is not in use for a
long me (more than 3 months).
• If you have any problems with this device, such as
seng up, maintaining or using, please
contact the manufacturer’s service personnel. Also,
please report to the manufacturer if any unexpected
operaon or events occur.
• Do not use the equipment if you noce a change in the
system's performance, if the system is damaged, or if
any of its components are worn or frayed.
• The equipment should not be used adjacent to or
stacked with other equipment. If adjacent or stacked
use is necessary, the equipment should be observed to
verify normal operaon in the configuraon in which it
is used.
Babysense monitors and alerts, but cannot prevent any
type of distress. The responsibility for applying first aid
rests on caretakers. The Babysense senses movements and
moon only, and cannot monitor other occurrences. The
purpose of the device is to alert when stopping or slowing
of movement occurs.
Babysense is a unique safety and reassurance system
which helps give parents peace of mind, alerng if
movements stop or become irregularly slow, giving crical
me to intervene. There are a number of cauonary steps,
which are internaonally recommended for SAFE
SLEEPING:
Babysense connually detects baby's moon and
movements, and will set off a sound and visual alarm if
movement stops for 20 seconds or if the monitor detects
less then 10 micro-movements per minute. The system's
non-touch sensor pads under the maress monitor
baby's movement without restraining him.
1. For inserng the baeries, remove the baery cover
by inserng a wide flat screw driver into the opening
recess (see illustraon 6). insert, in accordance with the
markings, 4 new and idencal size AA 1.5 volt baeries,
preferably alkaline and close cover.
Note: Please dispose of used baeries in accordance
with local waste regulaons.
2. Place control unit holder on the base of the crib or
bed and in between two bars as shown in illustraon 1.
3. Sensor pad installaon:
• When using for infant not yet able to crawl, place one
sensor pad as shown in illustraon 2. Make sure the
sensor is placed underneath baby’s locaon in crib.
• When baby begins to crawl, and is able to move onto
areas not "covered" by a single sensor pad, aach the
second sensor and place the two sensors as shown in
illustraon 2.
PLEASE NOTE: The sensors shall be placed with the
marking “THIS SIDE UP” facing upfront.
* Always lay baby to sleep on his or her back.
* Refrain from smoking near or around baby.
* Avoid over-heang of baby's surrounding.
* Do not leave any objects near your baby that can
cause suffocaon.
Babysense is an addion to these precauons.
Babysense 7 is a home movement monitor for infants up
to one year of age, and is not to be used with high-risk
infants requiring constant medical supervision. Medically
trained staff such as nurses, or non-medically trained users
such as parents or caregivers may use the Babysense.
Babysense 7 is intended for home use.
Warnings
Principal Of Operaon
Installaon
Please note
7
The original non-contact baby movement monitor
Now with enhanced sensitivity
Illustraon 1
Control unit holder
User Guide