WWW.BALTIMOREAIRCOIL.COM
4
TRILLIUMSERIES™ ADIABATIC CONDENSER
Rigging
Safety
Adequate precautions appropriate for the installation and location of these products should
be taken to safeguard the equipment and the premises from damage, and the public from
possible injury. The procedures listed in this manual must be thoroughly reviewed prior to
rigging. Read all dangers, warnings, cautions, notices, and notes detailed in the margins.
Pre-Rigging Checks
When the unit is delivered to the jobsite, it should be checked thoroughly to ensure all
required items have been received and are free of any shipping damage prior to signing the
bill of lading. If the unit will be in prolonged outdoor storage, refer to page 10.
The following parts should be inspected:
2
For TrilliumSeries™ Adiabatic products that have been shipped charged with Nitrogen,
verify that the coil maintained pressure (15 psi) by measuring the pressure with a Shrader
valve prior to installation.
Fan Motor(s)
Fan Guard(s)
Fan(s)
Drain Valve
Make-up Valve
Water Distribution System
Pump
Pump Valve (Optional)
Auto-Discrete Valve (Optional)
Sump and Gutters
Exterior Surfaces
Pre-Cooler Pads
EcoFlex™ Control Panel
Coils
Inlet Strainer(s) (Optional)
WARNING: Failure to use designated
lifting points can result in a
dropped load causing severe injury,
death, and/or property damage.
Lifts must be performed by qualified
riggers following BAC published
Rigging Instructions and generally
accepted lifting practices. The
use of supplemental safety slings
may also be required if the lift
circumstances warrant its use,
as determined by the rigging
contractor.
WARNING: Only personnel qualified
to do so should undertake the
installation, operation, maintenance
and repair of this equipment. Proper
care, procedures, and tools must be
used in handling, lifting, installing,
operating, maintaining, and
repairing this equipment to prevent
personal injury and/or property
damage.
To Next Page
Loading...
Need help?
General
