Manual Operation
To manually open the valve, make sure that the Controller
is not set to OFF (If it is set to OFF, press briefly on the
MODE button), then press and SET simultaneously.
The irrigation will continue until the interval defined
has passed. If the irrigation duration has been set to zero,
the valve will close after one minute.
To stop irrigating, press and SET simultaneously.
Irrigation Cycle Table
G75 Irrigation Window Controller
3
Example
You have just planted new seedlings, and you wish to
water them for five minutes, every hour, during the
hottest part of the day, every day. Set your Window
Start Time to 10:00; Window End Time to 14:00; ON
(Duration) Time to 05 (minutes); and OFF (Interval)
Time to 1:00. Your table will look like this:
Window Start Time
Window End Time
ON Time (Duration)
OFF Time (Interval)
Sun. Mon.
Tues.
Wed. Thurs. Fri.
Sat.
To Next Page
Loading...