Page 24
Routine cleaning may also be carried out from the BadgePass Print Suite by clicking on “Start cleaning”.
Before using your printer, remember to reset the gauge to the desired card thickness.
6. Remove any cards present in the feeder.
7. Double click the cleaning button on the control panel before inserting the cleaning card.
8. Remove the film from the adhesive card 1 and insert the cleaning card into the feeder as shown, adhesive side up 2. Cleaning starts.
9. The used cleaning card is ejected automatically into the output hopper.
6
7
8
9
Document History
BadgePass NXT5000 USER GUIDE
To Next Page
Loading...
