Badger Meter LM OG Series User Manual

Programmation of LM OG (CND) and LM OG-HF (CND) Page 12/28
LM_OG_BA_98_1105
Press 3 times „Total“ and
3 times „Reset“ to access
the programmation mode.
Measuring unit “L” (liter) is
flashing and can be
changed in L, GAL, QT or
PT when pressing “Reset”.
Press “Total” to confirm
the new measuring unit.
5. Programmation of LM OG (CND) and LM OG-HF (CND)
Press „Total“ one time to
switch on the meter.
„Total“ resettable
„Total“ not resettable
Measuring unit
Press both buttons
simultaneously to save the
programmation.
The meter then goes to the
sleeping mode.
The fifth figure can now
be changed.
The fourth figure can now
be chanced.
To access the next figure,
press “Total”.
Press “Total” one time
to change the k-factor.
The figure to be
changed is flashing
and can be modified
with “Reset”.
To change the next
figure, press “Total”.
The second figure can
now be chanced.
To access the next figure,
press “Total”.
The third figure can now
be chanced.
To access the next figure,
press “Total”.
After the sleeping mode,
please press „Total“ to
show the „normal“
display mode.
Sleeping mode
Press „Reset“ during 3
seconds and the
register displays the
check sum.

Badger Meter LM OG Series Specifications

General

Brand	Badger Meter
Model	LM OG Series
Category	Measuring Instruments
Language	English