Need help?Do you have a question about the Badger Meter E G2 Series and is the answer not in the manual?
General| Type | Electromagnetic Flow Meter |
|---|---|
| Accuracy | ±0.5% of reading |
| Pressure Rating | Up to 232 psi (16 bar) |
| Installation | Inline |
| Power Supply | 12 to 24 VDC |
| Output | 4-20mA, Pulse |
| Flow Rate Range | 0.03 to 1, 200 GPM |
| Housing Material | Stainless steel |
| Sensor Material | Stainless steel |
Explains how ultrasonic signals measure flow velocity and total volume.
Details potable and non-potable water uses and compliance standards.
Describes lead-free bronze alloy housing, transducers, and potted electronics.
Warning against lifting or moving the meter by its electronics, lid, or cables.
Meter's default mode, displays empty pipe icon, minimal data transmission.
Meter senses water, transmits data, transitions to active mode after 24 hours of full pipe.
Normal operation mode where the meter measures and displays consumption.
Guidelines for installing meters in outdoor meter boxes, including frost protection.
Precautions for indoor installations, focusing on electrical continuity and grounding.
How to turn on and interact with the meter's LCD screen.
Details the nine-digit display for total water consumption.
Shows current water flow rate in gallons per minute.
Displays current water pressure, with error codes for out-of-range conditions.
Explains how reading resolution varies based on the connected endpoint technology.
Wiring diagram for encoder-to-encoder connections.
Wiring diagram for encoder to scaled/unscaled output connections.
Wiring diagram for encoder to 4-20 mA output connections.
Wiring diagram for scaled/unscaled to 4-20 mA output connections.
To Next Page