EasyManuals Logo
Home>Badger Meter>Measuring Instruments>E G2 Series

Badger Meter E G2 Series User Manual

Badger Meter E G2 Series
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
ESM-UM-03099-EN-02
SAFETY INFORMATION
The installation of the E-Series Ultrasonic meter must comply with all applicable federal, state and local rules, regulations and
codes. Failure to read and follow these instructions can lead to misapplication or misuse of the meter, resulting in personal
injury and damage to equipment.
PRODUCT UNPACKING AND INSPECTION
To avoid damage in transit, E-Series Ultrasonic meters are shipped to the customer in special shipping containers. Upon
receipt of shipment, be sure to follow these unpacking and inspection procedures:
If damage to a shipping container is evident upon receipt of a meter, request that a representative of the carrier be present
when the meter is unpacked.
Carefully open the shipping container, following any instructions that may be marked on the container. Remove all
cushioning material surrounding the meter and carefully lift the meter from the container. Keep the container and all
packing material for possible use in reshipment or storage.
Visually inspect the meter and applicable accessory devices for any signs of damage such as scratches, loose or broken
parts or other physical damage that may have occurred during shipment.
OTE: N If damage is found, request an inspection by the carriers agent within 48 hours of delivery. Then file a claim with
the carrier. A claim for equipment damaged in transit is the responsibility of the customer.
MPORTANTI
Do not lift or move a meter by the electronics, lid or cable(s).
SPECIAL FITTINGS AND ACCESSORIES
To accommodate 5/8…1 inch meter installations, special fittings and accessories are available. Metal meter setters,
re-setters, horns and meter yokes are available for holding the service pipe in proper alignment to the meter and laying
length spacing. Metal setters and meter yokes can provide an electrical continuity to protect meters and consumers from
electrical shocks.
REMOVING A METER
WARNING
DEPRESSURIZE THE LINE BEFORE STARTING ANY DISASSEMBLY OPERATION. REMOVING A METER THAT IS UNDER LINE
PRESSURE CAN RESULT IN COMPONENTS BECOMING PROJECTILES, CAPABLE OF CAUSING PERSONAL INJURY.
Safety Information
Page 5 May 2021

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Badger Meter E G2 Series and is the answer not in the manual?

Badger Meter E G2 Series Specifications

General IconGeneral
BrandBadger Meter
ModelE G2 Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals