BAFANG DP C010.CN - Important Notice; Introduction of Display

2
BF-UM-C-DP C010.CN-EN June 2024
7.2 INTRODUCTION OF DISPLAY
• Model: DP C010.CN
• The housing is made of PC+ABS; the LCD
display windows is made of tempered glass;
the button is made of ABS:
7.1 IMPORTANT NOTICE
• If the error information from the display
cannot be corrected according to the inst-
ructions, please contact your retailer.
• The product is designed to be waterproof. It
is highly recommended to avoid submerging
the display under water.
• Do not clean the display with a steam jet,
high-pressure cleaner or water hose.
• Please use this product with care.
• Do not use thinners or other solvents to
clean the display. Such substances can
damage the surfaces.
• Warranty is not included due to wear and
normal use and aging.
• Any changesormodifications notexpress-
lyapprovedby the party responsible for
compliancecould voidtheuser's authori-
tytooperatetheequipment.
• This device complies with part 15 of
theFCCRules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
• This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of theFCCRu-
les. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruc-
tions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio
or television reception, which can be de-
termined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one of the following
measures: (1) Reorient or relocate the re-
ceiving antenna. (2) Increase the separation
between the equipment and receiver.(3)
Connect the equipment into an outlet on a
circuit different from that to which the recei-
ver is connected.(4) Consult the dealer or an
experienced radio/TV technician for help.