BAFANG DP C11.UART User Manual

11
DISPLAY MANUAL DP C11.UART
FUNCTIONS SETTING
interface, the all information will be metric;
if selecting the imperial, the all information
will be imperial.)
• Backlight setting
Enter into “Display Setting” interface and
briefly press “+” key or “-” key to select
“Brightness” and then briefly press “power”
key to confirm selection. Briefly press “+”
key or “-” key to select as “100%”/“75%”
/“50%”/“30%”/“10%”. After selection,
briefly press “power” key to save the setting
and exit back to the “Brightness” interface.
Press and hold “+” key and “-” key at the
same time to exit back to main interface
or select to “BACK”→“EXIT” to exit back to
main interface.
• “auto off” time setting
Enter into “Display Setting” interface and
briefly press “+” key or “-” to select “Auto
Off” and then briefly press “power” key
to confirm selection. Briefly press “+” key
or “-” key to select as “OFF”/“9”/“8”/“7”
/“6”/“5”/“4”/“3”/“2”/“1”. After selection,
briefly press “power” key to save the set-
ting and exit back to “Auto Off” interface.
Press and hold “+” key and “-” key at the
same time to exit back to main interface or
select “BACK”→“EXIT” to exit back to main
interface.
• Power-assistance mode setting
Enter into “Display Setting” interface and
briefly press “+” key or “-” key to select “As-
sist Mode” and then briefly press “power”
key to confirm setting. After setting, briefly
press “+” or “-” to select as “3”/“6”/“9”
and then briefly press “power” key to save
the setting and exit back to the “Assist
Mode” interface. Press and hold “+” key
and “-” key to exit back to main interface or
select “BACK”→“EXIT” to exit back to main
interface. The default level for the display is
level 5.

BAFANG DP C11.UART Specifications

General

Brand	BAFANG
Model	DP C11.UART
Category	Monitor
Language	English