BAFANG DP C11.UART User Manual

12
DISPLAY MANUAL DP C11.UART
2) Indication information introduction
• Check wheel diameter
Enter into “Information” interface and briefly
press “+” key or “-” key to select “Wheel
Size” and then briefly press “power” key to
check the wheel size.
Briefly press “power” key to exit back to “In-
formation” interface. Press and hold “+” key
and “-” key at the same time to exit back to
main interface or select “BACK”→“EXIT” to
exit back main interface.
• Check speed limit
Enter into “Information” interface and briefly
press “+” key or “-” key to select “Speed
Limit” and briefly press “power” key to
check the speed limit. Briefly press “power”
key again to exit back to “Information”
interface. Press and hold “+” key and “-”
key to exit back to main interface or select
“BACK”→“EXIT” to exit back main interface.
• Check battery information
Enter into “Information” interface and briefly
press “+” key or “-” key to select “Battery
Info.” And briefly press “power” to confirm
selection. Briefly press “+” key, it display in
turn b01 → b04 → b06 → b07 → b08 → b09 →
b10 → b11 → b12 → b13 → d00 → d01 → d02
→… → dn. briefly press “power” to exit back
to “Battery Info.” Press and hold “+” key
and “-” key to exit back main interface or
select“BACK” → “EXIT” to exit back to main
interface.
Code Code definition unit
b01 Current temperature
℃
b04 Total voltage mV
b06 Average current mA
b07 Remaining capacity mAh
b08 Full charge capacity mAh
b09 Relative SOC %
b10 Absolute SOC %
b11 Cycle times
b12
Maximum not charg-
ing time
Hour

BAFANG DP C11.UART Specifications

General

Brand	BAFANG
Model	DP C11.UART
Category	Monitor
Language	English