50
THE WATER SYSTEM
ADJUSTING YOUR PRESSURE SWITCH
Your pressure switch is factory set and should not normally require adjustment. However, if
adjustment is required due to the power supply voltage varying from the previous setting,
either because of battery drainage or higher voltage being supplied when the battery charger is
operating or in the event that your pump doesn’t switch off when you close the taps or pulses on
and off rapidly when the taps are fully open.
You should follow the below guidelines to re-adjust the pressure switch setting.
Proudly powering your Bailey Caravan shower experience
www.ecocamel.com
Whale Support
Call today for advice on water
and heating systems
Taps and
Showers
Space Heating
Plumbing
Water
Pumps
Control
Water Heating
Phoneline
available
7 days a
week
Market Leaders in innovative water
and heating system technology
Tel: 0845 217 2933
E-mail: info@whalepumps.com
www.whalepumps.com
Proud to manufacture in the UK
NEW
Facebook “f” Logo CMYK / .eps Facebook “f” Logo CMYK / .eps
To Next Page
Loading...
