VIGIL3 Voice Alarm
Overview, Architecture and Configuration
VIGIL3 Overview, Architecture & Configuration issue 2 17
4 Configuration
The following is an introduction into how the configuration tools
in VIGIL3 operate. It is not intended as in depth instruction on
how to configure a VIGIL3 system.
Configuration data and Voice Alarm Messages are stored within
every BV3AOM8 module.
Configuration changes and message upload are performed by
connecting a PC to any BV3AOM8 module over USB and running
the VIGIL3 Configurator PC application. Once the changes are
made they are uploaded to the local module and then
automatically replicated to every BV3AOM8.
Configuration in a VIGIL3 system is hierarchical and consists of
sections for;
• System - including system wide settings, messages and
chimes
• Audio Input Modules - including RS485 port configuration,
Access profiles, VOX settings etc.
• Audio Output Modules - including volumes, audio priorities
per output etc.
New modules, messages, chimes etc. can be added by right
clicking and the configuration changed by expanding the tree
view under each section.
To Next Page
Loading...