Balluff BNI PNT-508-105-Z031-002 - Mechanical Connection; Electrical Connection; Power Supply; Grounding

Balluff Network Interface ProfiNet™
www.balluff.com
7
3 Getting Started
3.2. Mechanical
connection
The module is secured by means of two M6 screws and two washers.
Insulation support is available separately.
3.3. Electrical
connection
Power supply
Power supply
Pin
Function
Description
1
24 V
Module / sensor power supply (max. 16A)
2
0 V
GND Module / sensor power supply
3
+24 V
Actuator power supply (max. 16A)
4
0 V
GND actuator power supply
5
FE
Function ground
Note
Provide sensor/bus power and actuator power from separate power sources if
possible. Total current <16A per Pin. The total current of all modules may not
exceed 16A even when daisy chaining the power supply.
Grounding
Note
The ground connection between housing and machine must have a low
impedance and be as short as possible.