1-800-543-8390 • WWW.BALLUFF.COM
4
BTL5-A/C/E/G_ _-M/U_ _ _ _-P-S 32/KA_ _
Micropulse Linear Position Transducer
Analog Output/Profile Housing
™
Ensure that the distance
E between parts made of
magnetizable material and
the BTL5-P-5500-2
magnet is at least 12 mm (Fig. 3-3).
3 Installation (cont.)
Fig. 3-1: Dimensional drawing (BTL5...P-S 32 transducer with floating magnet BTL5-P-3800-2)
Mounting brackets with isolation bushings and M5 x 22
socket head cap screws, DIN 912, max. tightening torque
2 Nm
3.2 Floating magnets
The floating magnet (Figs. 3-2
to 3-4) is attached to the
moving member of the
machine using non-magnetiz-
able screws (brass, alumi-
num). To ensure the accuracy
of the transducer system, the
moving member must carry
the magnet on a track parallel
to the transducer.
The following table provides
figures in [mm] for the spacing
which must be maintained
between magnet and
transducer and for the
permissible center offset:
max. permissible
tightening torque 2 Nm
55
28
45
21
Ø 4.2
20
61 +10
1
15
E
E
C
D
Fig. 3-2: BTL5-P-3800-2 magnet
Fig. 3-3: BTL5-P-5500-2 magnet
Fig. 3-4: BTL5-P-4500-1
electromagnet (24 V/100 mA)
BTL5-P-4500-1 magnet, special
features: Multiple magnets on
the same transducer can be
turned on and off individually
(PLC control signal).
The stroke range is offset
4 mm towards the BTL
connector/cable (Fig. 3-4).
NL
Nominal stroke
BTL5-P-3800-2
BTL5-P-5500-2
BTL5-P-4500-1
0.1 ... 4
5 ... 15
0.1 ... 2
± 2
± 15
± 2
Magnet type
Distance
“D”
Offset
“C”
P_Analog_122003.pmd 12/11/2003, 3:59 PM4
To Next Page
Loading...
Need help?
General
