Need help?Do you have a question about the Balluff Micropulse BTL5-A series and is the answer not in the manual?
General| Type | Magnetostrictive Linear Position Transducer |
|---|---|
| Operating temperature | -40°C to +85°C |
| Protection class | IP67 |
| Housing material | Stainless steel or aluminum |
| Output signal | Analog |
| Operating voltage | 10 to 30 VDC |
| Supply Voltage | 10 to 30 VDC |
| Linearity deviation | ±0.02 % F.S. |
| Linearity Error | ±0.02 % F.S. |
Specifies intended use of the Micropulse transducer in machines with a controller for position measurement.
Explains how to replace factory-set null/endpoints by moving the magnet to new positions and pressing buttons.
Details setting new start/end values by moving the magnet and using buttons to adjust values, allowing for slope adjustments.
Describes how to restore the transducer to its original factory default settings.
Details the sequence of button presses and magnet movements for setting null and end points.
Guides on moving the magnet to the start position and holding a button to set the start value.
Guides on moving the magnet to the end position and holding a button to set the end value.
Explains the initial button presses required to prepare for the reset operation.
Details holding both buttons for 6s to restore factory settings and then releasing them.
To Next Page