Bandit 2550 - Page 47

Bandit
43
Copyright 4/21
MODELS 2550/2550T MAINTENANCE
1. Replace hydraulic lter(s) after rst 10 hours then quarterly or every 400 hours.
3 MONTH CHECK LIST
Every three months these checks must be made:
OK REPAIRED
1. Inspect and clean steering wheel hub bearings, cups, and seals. Grease steering
wheel hub bearings. Replace seals if ever removed (Model 2550 w/ 2 Wheel Drive)
2. Drain and clean the fuel tank.
3. Change hydraulic oil and ush the hydraulic tank.
4. Replace hydraulic suction screen(s) annually or every 2000 hours.
YEARLY CHECK LIST
OK REPAIRED
Every three months these checks must be made:
BOLT TORQUE CHART
(THESE TORQUES ARE BASED ON DRY, CLEAN THREADS)
DESCRIPTION BOLT SIZE TORQUE (FT.-LBS.) TORQUE (Nm)
Cutter Wheel Revolution Tooth Nut 5/8” - 18 NF 150 203
Cutter Wheel Green Tooth Pocket Tooth Nut 5/8” - 18 NF 180 244
Cutter Wheel Green Tooth Nut N/A 35 47
Cutter Wheel Tomahawk Tooth 5/8” - 18 NF 120 - 150 162 - 203
Cutter Wheel Coupler: 1 3/4” Shaft (Start 3/13) N/A 30 41
Cutter Wheel Coupler: 1 1/4” Shaft (Pre 3/13) N/A 13 18
Engine Hold Downs 1/2” - 13 NC 95 129
Lug Nuts 1/2” - 20 NF 90 - 120 122 - 163
Before tightening bolts be sure you have the correct size bolt for the correct amount of torque.
Use only factory approved knives and hardware.