Bandit 2550 - Page 48

Bandit
44
Copyright 4/21
MODELS 2550/2550T
Use as a reference only, locations may vary depending on options or component manufacturer.
Lubrication point instructions are described on the machine, in the Lubrication & Coolant
Section and Maintenance Section of this manual, or component manufacturer’s manual.
NOTICE
CHECK
# DESCRIPTION DAY WEEK MONTH PROCEDURE
1 Cutter Wheel Arm Pivot Bushings X 1 - 2 shots of grease - wipe o󰀨 excess
2 Swing Pivot Ass’y Bushings X 1 - 2 shots of grease - wipe o󰀨 excess
3 Steering Axle Pivot Bushings X 1 - 2 shots of grease - wipe o󰀨 excess
4 Steering Bushings X 1 - 2 shots of grease - wipe o󰀨 excess
5 Cylinder Lug Pin Bushings X 1 - 2 shots of grease - wipe o󰀨 excess
6 Swing Out Pivot Bushings (if equipped) X 1 - 2 shots of grease - wipe o󰀨 excess
7
Steel Friction Areas: pivoting, hinged,
sliding, rolling
X
Lubricate (i.e. cutter wheel guard,
control box doors, etc.)
8 Grading Blade Pivot Bushings X 1 - 2 shots of grease - wipe o󰀨 excess
9 Cutter Wheel Engagement Cable X Lubricate cable ends with SAE 10W/30
10 Wheel Hub Bearings YEARLY Grease until old grease is pumped out
LUBRICATION CHART - 2550
MAINTENANCE
7
5
1
5
2
5