Bandit 75 - Controls Operation; Feedwheel Control Bar and Pivot Adjustment

Bandit13
MODEL 75 OPERATION
CONTROLS
CORRECT OPERATION OF FEEDWHEEL CONTROL BAR
ADJUSTING TENSION FOR CONTROL BAR PIVOT AND LAST CHANCE CABLE
Normal wear requires periodical adjustment of pivot
tension.
Feedwheel control bar should pivot with little e󰀨 ort,
by hand or with a pull on the “Last Chance” cables.
Lubricate pivot points of the feedwheel control bar
weekly.
Adjust pivot tension
with the tightness of
inside friction nuts.
Secure adjustment
with outside jam nuts
FEEDING
OFF
PUSH TO
REVERSE
FEEDING
If you are in the
area of the infeed
hopper, always be
prepared to operate
and within easy reach
of the feedwheel
control bar