Bandit15
MODEL 75 OPERATION
CONTROL OPERATING PROCEDURES
FEEDWHEEL TRAP DOOR
(DUAL FEEDWHEEL OPTION)
FEEDWHEEL CONTROL BAR
Before opening or closing the feedwheel trap door:
disengage clutch, wait for the disc to come to a complete
stop, turn o engine, remove the ignition key, make
sure the ignition key is in your possession, install the
disc lock pin, and disconnect the battery. In the event
that dirty material is being run through the chipper
the feedwheel trap door can be opened.
SAFETY INSTRUCTIONS
The feedwheel control bar operates the
feedwheel(s). To make the feedwheel(s) operate
so they are pulling material into the machine, pull
the control handle towards the operator away from
the machine. To make the feedwheel(s) operate so
they are pushing material out of the machine, away
from the chipper disc, the control handle should be
pushed away from the operator, away from you and
towards the machine. The control bar is in the o
position when it is in the center location.
To Next Page
Loading...
