Bandit21
MODEL 75 OPERATION
OPTIONAL HYDRAULIC BUMP BAR OPERATION
The hydraulic bump bar is an optional device
which may help prevent accidents. Do not rely on
the hydraulic bump bar to prevent infeed accidents.
Never reach or kick into the infeed hopper for any
reason. Serious injury or death will result.
HYDRAULIC
BUMP BAR
HYDRAULIC
BUMP BAR
RESET
PUSH TO
ACTIVATE
MOMENTARY
FEED / REVERSE
•
The optional Hydraulic Bump Bar comes set from
the factory and is non adjustable.
•
If the Hydraulic Bump Bar is pushed, the
feedwheels stop.
•
After the Hydraulic Bump Bar has been pushed,
the operator will need to reset it. Push the
Hydraulic Bump Bar Reset towards the tongue
of the machine. After the operator has done this,
the feedwheels will operate again.
•
If there is wood or a branch that is pushing the
Hydraulic Bump Bar, the operator can push the
button shown above to momentarily operate the
feedwheels to reverse the wood back out. Then
the operator can reposition the wood or remove
the wood and cut the branch o before feeding
again.
DANGER
To Next Page
Loading...
